Do you need plumbers putty to install a faucet?
The faucet will typically come with a rubber or plastic gasket, or a trim ring, that you will need to place over the faucet holes in the sink. Sometimes, you may be directed to use plumber’s putty instead of a gasket. Either way, the point of these pieces is to keep water from leaking from the sink into your cabinet.
What do you need to know about replacing a faucet?
There will be two, one for hot water and one for cold water. Look for shut-off valves—small handles that when turned clockwise will shut off the water to the faucet. If you don’t have shut-off valves, you’ll need to turn the main water supply off.
Can you turn off hot water from bathroom faucet?
Depending on your plumbing, you may have a single water valve for the entire faucet, or you may have two separate valves for the hot and cold water. If you have trouble locating the shutoff valve, you can turn off the water supply to the entire line running to the bathroom sink.
How are hot and cold water lines connected in a faucet?
Make sure hot water and cold water lines are connected to proper supply tubes on faucet assembly. When you attach lines, be sure to use two wrenches. One holds fitting while the other turns nut on water supply line. Step 8: Turn on hot and cold water supplies to fixture.
Which is the correct way to unscrew a water faucet?
If you have a one handle/one faucet configuration there should only be one nut to unscrew. Remember “righty-tighty, lefty loosey” when attacking that nut. Clockwise makes it tighter, counter clockwise makes it looser. Once the water lines are off, there may be larger nuts that hold the faucet against the bottom of the sink and countertop.
How to replace a hot water faucet in a bathroom?
1 Turn the water supply back on. 2 Turn on the faucet and open both the cold and hot water taps. 3 Inspect all the new connections and check for leaks above and below the sink.
There will be two, one for hot water and one for cold water. Look for shut-off valves—small handles that when turned clockwise will shut off the water to the faucet. If you don’t have shut-off valves, you’ll need to turn the main water supply off.
How to reverse hot and cold on a Moen faucet?
The faucet guide will contain specific information on handle assemblies associate with that style of product. If the hot and cold are reversed, the stem of the cartridge can be adjusted. To change the polarity, rotate the stem of the cartridge 180 degrees (1/2 turn). It is not necessary to remove the cartridge.
How to reverse hot and cold for a 1225?
Under the sink, if the hot water supply line is on the left and the cold water supply line is on the right, the notch on the cartridge needs to face the front of the faucet. Under the sink, if the hot water supply line is on the right and the cold water supply line is on the left, the notch on the cartridge needs to face the back of the faucet.